EasyManua.ls Logo

DAN DRYER Loki - General Safety Information; Circuit Diagram

DAN DRYER Loki
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
WARNING
• All units must be equipped with a 3-wire service. Connect the ground wire according
to the instructions.
This product must be installed only by qualied persons. Use 2.0mm
2
(AWG) NO.14 wiring.
• Turn off the power to the unit before servicing or cleaning. All wires must be disconnected.
• Incorrect installation, defect power cords, or failure to properly ground unit could result in
electrical shock or life-threatening injuries.
NOTE
We do not recommend to install this product less than 300 mm above washbasin, tabletop or
other surface. This product is suitable for indoor use only.
Type Y connection: If the power supply cord is damaged, it must be replaced immediately.
Only qualied persons shall be permitted to replace the cord to avoid a hazard. Disconnect the
electricity supply cord according to instructions.
This product is not intended for use by persons (inclusive children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they are
supervised or have been given instruction concerning use of the product by a person
responsible for their safety.
Children should be supervised to ensure this product is used correctly.
GENERAL SAFETY INFORMATION
CIRCUIT DIAGRAM
!