Danby DAC5277EE - Page 10

5. Completing the Installation for All Models
• Carefully slide the air conditioner back into
the cabinet, (in window)
(please seek assistance for this procedure)
Reinstall (slide-out-chassis) security screws
removed earlier on the (lower left/right) side of
the cabinet. (Fig.7)
• Expand the shutter frames (fully) on each side
and secure the top of the frames to the window
sash using one 3/4”(19.1mm) screw & flat
washer on eash side.(Fig.23)
• Install shutter clamp on each side of the (lower)
shutter and secure to window sill using one
3/4” (19.1 mm)screw & flat washer on each side.
(Fig.23)
5a. Reinstalling Front Panel Grill:
• Position the front panel assembly on the
cabinet starting at the top. The front panel lock
tabs must be inserted into the retaining slots in
the cabinet.
Repeat this procedure on all sides, making sure
the fresh air ventilation lever arm and power
cord are properly installed back to their original
position.
• Secure the front grill to the cabinet using the
Phillips screws removed earlier. Fig’s.t & 2.
• Install the air filter.
• Cut the second foam seal to fit the opening
between the top of the inside and outside
window. (Fig. 24.)
• Some installations may require additional
sealing around the window and air conditioner.
Check for any air leaks and seal where
necessary.
• Under very humid conditions, water removal
may be excessive enough to overflow from the
rear of the unit or increase noise levels of the
air conditioner. If this occurs, consider attaching
a standard drain (garden) hose (not
included) to the drain plug at the rear of the
unit, allowing condensation to run off
conveniently. (Fig. 25.)
9