Danby DAC5277EE - Page 11

7. Electronic Control Features
LED DISPLAY: The LED window displays the
following information independently.
• Set Cooling Temperature
• Ambient Room Temperature
• Auto on/off Timer Programs
• El = (Clean Air Filter)
NOTE: During normal operating conditions, (after all
settings are complete) the LED readout will always
default to show (display) the “ambient room
temperature”. In order to view the “set” temperature
of the air conditioner, press either of the temperature
^ key pads once.
Control panel
(^) POWER SWITCH: turns power on/off
" <£> ''(SWING):Activates the automatic air swing
(oscillation)feature.
"t£"(ENERGY SAVER):Press and hold the"i£
(SWING) keypad for 3 seconds to activate the
ENERGY SAVER program.This program is
designed to reduce energy consumption by
limiting (restricting)operation of the fan motor
with the operation of the compressor.i.e.
Compressor off/fan off
Compressor on/fan on
NOTE: When the ENERGY SAVER feature is not
selected, the fan motor operates continuously,
even after the compressor (cooling mode) has
cycled off. i.e.
compressor on / fan on
compressor off / fan on
MODE: Activates the FAN or COOLING mode.
"v£)"(TIMER):Activates the auto start or auto
stop timer program from 0—12 hours.(1 hour
increments).
"sGf^'TONE TOUCH):Activates a (factory)pre-set
temperature setting of 22”C(+/-2“C)71,6°F.
" "(FAN):Activates fan speed settings.
"4^"(high fan),"%"(medium fan),",JV'(iowfan).
KEYPAD: Activates (increases) temperature
settings.
^ KEYPAD: Activates (decreases) temperature
settings.
CAUTION
Wait three minutes before adjusting/changing
temperature settings. Adjusting temperatures too
quickly may cause the compressor overload to
trip, resulting in a blown fuse.
Fresh Air Ventilation should be kept in the
“closed” position during air conditioning mode.
Fresh Air Ventilation should be kept in the “open”
position during "fan mode” only when clearing
smoke and/or odors from the room.
10