EasyManua.ls Logo

Danby DDR050BJPWDB-RF - Frequently Asked Questions; Troubleshooting Guide

Danby DDR050BJPWDB-RF
25 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FREQUENTLY ASKED QUESTIONS
7
What is the best humidity setting?
We recommend setting your dehumidifi er between
40-45%.
Is the air that comes out of the dehumidifi er
supposed to be hot?
Yes, usually this air feels warm.
Why isn’t the dehumidifi er collecting any
water?
There may not be enough humidity in your
environment or the relative humidity might be set
higher than ambient humidity.
Does the fan run continuously?
In continuous mode, the fan will run continuously.
In smart dehumidify mode or manual mode the fan
will cycle on and off.
Can I use an extension cord?
No, the dehumidifi er is built to operate using the
power cord provided.
Does the timer cycle on and off forever?
The on and off timers can be used at the same time
however, they will only cycle one time and then
resume normal functioning.
How do I hook up my direct drain?
Remove the cover from the continuous drain outlet
and attach the provided connector and drain hose
to the back of the appliance. Direct the other end of
the drain hose to a bucket or fl oor drain.
Does the fi lter light come on when it is
dirty?
The fi lter light comes on automatically after about
250 hours of use even if the fi lter is clean. Clean the
lter and then press the fi lter button to turn the fi lter
light off.
What is the plastic piece in the bucket?
This rounded piece is called a buckle and is clipped
on to the back of the dehumidifi er. It is used to wrap
the power cord during long term storage of the
dehumidifi er.
TROUBLESHOOTING
Appliance will not operate
Plug is not fully inserted into the wall outlet
Blown fuse or circuit breaker
Ambient humidity is lower than the set humidity
Bucket is full or is not in the proper position
Insuf cient dehumidifying
• Air lter is dirty
Blocked air fl ow
Appliance size is too small for application
Ambient humidity is lower than the set humidity
Noise
• Air lter is dirty
Bucket is not in proper position
Floor surface is not level
Odors
Formation of mold or mildew on internal wet
surfaces
Place an algaecide tablet in the water bucket
Water on fl oor
Hose connection is loose
Drain cover has been removed
Frost build up
When ambient temperature is below 5°C (41°F)
frost may form
Switch the appliance to fan only mode until the
frost melts

Related product manuals