Danby DKC645BLS - Setting up Your Chill N Tap

SETTING UP YOUR CHILL № TAP
ASSEMBLY
INSTRUCTION:
1.
Installation
of
Top
Rail:
(as
show
in
Fig
1).
2. Installation of CO, Cylinder Support: Install the cylinder
‘Support onto the four studs located on the exterior back
wall of the cabinet. (no tools required) Ау
the
cylinder
support
with
ће
studs
and
push
down
emy.
See Fig. 2
з. Installation of CO, Cylinder: Install your * Алу charged
Со;
cylinder
into
the
support
stand.
IMPORTANT
NOTICE:
ALWAYS
EXERCISE
EXTREME
CAUTION
WHEN
HANDLING
PRESSURIZED
Со;
CYLINDERS,
4. Installation of СО; Regulator: Atach the СО; Regulator to
the СО cylinder by scrowing the regui
valva and tighten (snug) using an adjustable wrench.
Soe Fig. 3
10