Danby DKC645BLS - Troubleshooting

JU CALL FOR SERVICE
TROUBLESHOOTING
Problem Possible Causes What To Do
Excess formation of Recent keg agtaton 1f me keg has reconty buen moved (ranspored) you
foam head: злой let stand fora minimum of two (2) hours
before
tapping
Improper regulator Мау thatthe LOW side (CO) pressure is reading
seine
between
10
-
12
ps
Internal
temperature
of
—
Ensure
that
the
keg
cooler
is
operating
within
36
-
40
eg cooler (or beer koa) F (2.4" C). H the boor hag has boon exposed lo a
too warm. warm envronment tor an extended penod дме ï
Scion! ime to cool before attempting a pour
Pressure
buid
up.
Activo
th
pressure
ree
valve
that
ls
located
on
ine
коў coupler fo 3 seconds
"proper draw technique ses "Using Proper Draw Technique” on pg. 1б.
CTT == Verfy har the LOW sido (60; pressure e reading
formation of foam. seting
between 10 = 1205.
isseware i nol
Ress on gasswr in the form of ой wil quicky
isolve the formation cf foam. (see "Deer Clean
E
- Glassware" on pg. 18)
= 7 = RON
=
ACCRUE
LowErpty СО; yender
Check tat HIGH pressure gauge s nï roading 107
ра Refl d necessary,
No beer flow from
dispensar
Closed CO, valve andlor
зало valve.
Ensure hal both tho СО, cylinder and regulator shur
Of valve are open.
Empty СО; cylinder.
Check that HIGH pressure gauge i not reading `O"
psi Refl f necessary.
Empty
beer
keg
Replace
beer
keg
Line or dispersar
Very mat mere are no Kan or obstructions in ether
кее e э ine (red) or dispenser уле (clear) and tna
esther are тогот
Improper connecton(s) Ensure al connections are secure and al seals are in
19
ace and in good condition.