Danby DKC645BLS - Castor Installation

SETTING UP YOUR CHILL N' TAP
IMPORTANT
NOTICE:
Before
proceeding
with
the
configuration
options
on
this
page,
remove
keg
and
the CO,
cylinder
(f
installed)
rom
the
Keg
Cooler.
Once
complete,
allow the unit to stand upright for 1 hour before putting the unit into operation,
Changing Direction
lof the Door “Swing
1. Lay the unit on ts back
2, Remove the kickplate by romov-
ing he ese retaining screws,
(locations shown in Fig E)
3. Remove the four screws locat
ой on tha lower door hinge Fig
Ez.
4. PUN the door downward unt R
releases trom the upper hinge.
pin.
Remove the plastic screw сар
from the top left hand (Fig E3)
so and instal on the top.
fight hand ide o the door
6,
Unscrew
the
upper
door
hinge
pin
(Fig
£4)
from
the
right
side.
of the worktop and instal # оп
iho loft sido of the worktop
7. Postion те main door back on
the cabinet and push up unti
the op hinge pin is inserted
aio the top of he door
70. Make sure to align the
door and cabinet
olore
fastening
the lower hinge screws
tothe cabinet
8. Remove the lower support pin
from the door and reposition f
Fig. ES
9. Reinstall the ower supporto
on the right side of the door
no”
l |
T. Reinstall he kick
piae
me
©
1. Lay the unit on Its back.
=
2. Remove те four)
acjustable feet
3. Castor instalation
(as
show
in
Fig
A).
13