Danby DKC645BLS - Page 15

TING INSTRUCTIONS
an Emply
Close the main cylinder valve (A) by tuming in a
clockwise drecton. See Fig 11
Close the secondary shut-off valve (C) by
turning to orizontal" (eastwest) postion on
lower stom pipe, See Fig.
Remove the air ine clamp and hose from the
regulator
Remove tho regulator assembly (E) tram empty
cylinder See Fig.11
Remove dust cap from new andor placement
CO; cylinder
Ro-attach regulator assembly (E) to
mewireplacomont cyindar See Fig 11
Re-attach the air line hoso to regulator (barb.
connection) and secure with clamp.
Slowly open main valve (A) all the way.
See Fig. 11
15
9. Readpst regulator pressure (D) (f necessary)
between 10 ~ 12 pais,
10. Open the secondary shut-off valve (C]oy turing
to "vertical" (nonnisoutn) positon on lower stem
po
* Pror to tapping the keg, ensure the beer faucet is in
the off position.
+ Completely remove the Gust cover (бепібсабоп cap)
from the beer keg.
+ Check that the keg coupler (handle) is in the up (of
position. See Fig. 7
- insert the keg coupler into the locking neck of the beer
Kag and apply a tum clockwise to lock into positon
+ РШ keg coupler handie out and downward unt f locks
into
postion.
See
Fig.
8
This
activates
both
the
beer
and
(CO2)
pressure
ine.
The keg is now tapped and ready to draw beer.