Danby DPA100D1MDD - Operating Conditions; Tools for Window Kit Installation; Features and Components

READ AND FOLLOW ALL SAFETY INSTRUCTIONS
IMPORTANT SAFETY INFORMATION
OPERATING
CONDITIONS
The air conditioner must be operated within the temperature ranges indicated below:
MODE ROOM TEMPERATURE
COOL 17°C (62°F) - 35°C (95°F)
DRY 13°C (55°F) - 35°C (95°F)
*HEAT (heat pump type) 5°C (41°F) - 30°C (86°F)
*HEAT (electrical or heat pump) <30°C (86°F)
(*) Optional feature, some models may not have this feature.
Note: Performance may be reduced outside of these operating temperatures.
TOOLS FOR WINDOW
KIT INSTALLATION
1. Screwdriver (medium size, Phillips)
2. Tape measure or ruler
3. Knife or scissors
4. Saw (In the event that the window kit needs to be cut down in size because the window is too narrow for direct
installation). See www.danby.com for general instruction guide.
FEATURES AND COMPONENTS
1. Caster
2. Handle (L)
3. Control Panel
4. Wind louver
5. Air inlet grille
6. Air inlet
7. Remote control
8. Exhaust outlet
9. Handle (R)
10. Exhaust pipe assembly
11. Window sealing plate
assembly
3
11