Danby DPAC10030 - Setting Combined AUTO-ON;OFF Timers

CLOCK: Allows you to initiate and/or change the
TIME OF DAY setting. To activate clock mode both
the
TIMER ON and TIMER OFF buttons must be
pressed simultaneously.
TIMER ON: Used to initiate the AUTO ON start time
TIMER OFF:Used to initiate the AUTO OFF
stop time
I/O
MODE FAN
SWING
CLOCK
TIMER ON TIMER OFF
WATER FULL
RUN
TEMP/TIMER
ADJ
Fig. 5
Fig. 6
A warning signal (beep) will sound for 20
seconds and the Water Full indicator light
will illuminate.
Key Pad Functions Fig. 5
The control panel on this unit “illuminates”
automatically when any key pad is depressed. This
“illumination” feature will “self-deactivate” (turn-off)
automatically approx. 20 seconds after the last key
pad is depressed.
I/O: Power Switch On / Off.
Indicator Lights:
RUN:
Blue Light illuminates to indicate selected mode
is operational.
Water Full Indicator Light:
Red Light illuminates indicating the internal water tank
(only) is full and/or incorrectly positioned inside
the cabinet. Fig. 6.
FAN: Selects optional fan speeds.
Fan Speed Options:
Cooling Mode: Low-Medium-High-Auto
Dry - Dehumidifying Mode: Low. (only)
Fan Mode: Low-Medium-High
Temp/Timer Adj:
:
Used to adjust Time of Day Clock settings forward
(1 min./1hr. increments).
Used to adjust Temperature settings forward
(1°C increments).
Used to adjust Temperature settings forward
(1°F increments).
Used to adjust Timer-On/Off settings forward
(1min/1hr. increments)
: Used to adjust Time of Day Clock settings backward
(1 min/1hr. increments).
Used to adjust Temperature settings backward
(1°C increments).
Used to adjust Temperature settings backward
(1
°
F increments).
Used to adjust Timer -On/Off settings backward
(1min/1hr. increments)
SWING: Allows the vertical louver grills to oscillate
from side to side automatically.
Temperature Conversion Chart
°C 10 11 12 13 14 15 16 17 18 19 20 21
°
F
50
52
54
55
57
59 61 63 64 66 68 70
°C 22 23 24 25 26 27 28 29 30 31 32 33
°
F
72
73
75 77 79 81 82 84 86 88 90 91
NOTE: This appliance provides a feature that will allow you the
option of setting “temperatures” in “Celsius” or “Fahrenheit”.
To change the temperature display on the main unit, press both
the (Temp/Timer ADJ) keypads “simultaneously” to alternate
between the C & F scale
Celisus scale allows adjustments in increments of 1˚C
Farenheight scale allows adjustments in increments of 1˚F
I/O
MODE
FAN
SWING
CLOCK
TIMER ON TIMER OFF
WATER FULL
RUN
TEMP/TIMER
ADJ
8