EasyManua.ls Logo

Danby Premiere DDR70B3PWP - User Manual

Danby Premiere DDR70B3PWP
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DANBY PRODUCTS LIMITED, ONTARIO, CANADA N1H 6Z9
DANBY PRODUCTS INC., FINDLAY, OHIO, USA 45840
2:1(5¶686($1'&$5(*8,'(
*8,'('¶87,/,6$7,21(7'(175(7,(1
*8Ë$'(87,/,=$&,Ï1<&8,'$'23$5$(/3523,(7$5,2
02'(/02'Ê/(02'(/2
)25<2856$)(7<Read these instructions carefully before operating the unit.
32859275(6e&85,7eLire attentivement ces instructions avant d’utiliser l’appareil.
3$5$686(*85,'$'Lea y observe todas las reglas de seguridad y las instrucciones de operación antes
de usar este producto.
(1*/,6+
PORTABLE DEHUMIDIFIER
DESHUMIDIFICATEUR PORTATIF
DESHUMIDIFICADOR PORTÁTIL
DDR70B3PWP
20.11.14
To Buy: Visit www.sylvane.com or call (800) 934-9194
For Product Support: Contact Danby at 1-800-263-2629

Other manuals for Danby Premiere DDR70B3PWP

Questions and Answers

  • G
    Gloria SmithJul 31, 2025
    Why is my Danby Portable dehumidifier not drying the air properly?
    • J
      John MartinezJul 31, 2025
      If your Danby Portable dehumidifier isn't drying the air as expected, several factors could be at play. First, allow at least 24 hours for it to reach the desired dryness, especially after initial setup. Ensure that curtains, blinds, or furniture aren't blocking airflow to the unit. Check and clean the air filter. Adjust the humidity control to a lower percentage for drier air. Make sure all doors and windows are tightly closed. Position the dehumidifier away from the clothes dryer, and ensure the dryer is properly vented outside. Remember that moisture removal is most effective at higher room temperatures, above 5°C (41°F).
  • E
    Edward MartinAug 6, 2025
    How to fix a Danby Portable dehumidifier that does not start?
    • A
      Amber GreenAug 6, 2025
      If your Danby Portable dehumidifier doesn't start, ensure it's fully plugged into the outlet. Check your house's fuse or circuit breaker and replace or reset if necessary. If the dehumidifier has reached its preset level or the bucket is full, the unit will turn off automatically; change to a lower setting or empty the bucket and replace it correctly. The bucket must be securely in place for the unit to operate. Also, there's a protective time delay of up to 3 minutes to prevent compressor overload, so the unit might not restart immediately after being turned off and on.
  • P
    Patrick WadeAug 11, 2025
    Why does my Danby Portable dehumidifier run too much?
    • C
      Chad ClarkAug 11, 2025
      If your Danby Portable dehumidifier is running excessively, it might be due to the area being too large for the unit's capacity. Alternatively, open doors and windows can also cause this issue. To resolve this, close all doors and windows to reduce the load on the dehumidifier. If the problem persists, consider that the dehumidifier's capacity may not be adequate for the space.
  • K
    Kenneth DeleonAug 15, 2025
    What to do if there is water on the floor near my Danby Portable dehumidifier?
    • C
      Chelsea PriceAug 15, 2025
      If you find water on the floor near your Danby Portable dehumidifier, check the hose connection for any looseness. See the “Continuous Drain” section. If you're using the bucket to collect water, disconnect the hose. See “Continuous Drain” section.
  • A
    Amber EllisAug 20, 2025
    Why does frost appear on the coils of my Danby Portable dehumidifier?
    • J
      Justin RodriguezAug 20, 2025
      If you notice frost on the coils of your Danby Portable dehumidifier, especially soon after turning it on or if the room temperature is below 5°C (41°F), this is generally normal. The frost should disappear within about 60 minutes. See the “Defrost” section.
  • S
    Shane MccarthyAug 26, 2025
    Why can't I set the controls on my Danby Portable dehumidifier?
    • C
      Catherine CabreraAug 26, 2025
      If you find that the controls on your Danby Portable dehumidifier cannot be set, this is normal behavior when the compressor turns off. The fan will continue to run automatically for approximately 3 minutes at a fixed setting. Wait about 3 minutes, and then you should be able to set the fan as desired.

Summary

Important Safety Information

Electrical Requirements

Details on power supply, wiring, and grounding for safe operation.

Grounding Instructions

Proper grounding methods to prevent electrical shock hazards.

Safety Precautions

General safety guidelines for using the dehumidifier.

Installation Instructions

Location

Guidance on selecting an appropriate place for the unit to ensure optimal performance.

Care and Maintenance

Troubleshooting

Unit Not Starting

Solutions for issues related to the dehumidifier failing to power on.

Poor Moisture Removal

Steps to take when the unit is not effectively drying the air.

Limited Carry-In Appliance Warranty

Warranty Terms and Conditions

Details of the warranty period, coverage, and purchaser responsibilities.

Danby Premiere DDR70B3PWP Specifications

General IconGeneral
ModelDDR70B3PWP
TypeDehumidifier
Dehumidifying Capacity70 pints per day
Energy Star RatedYes
Automatic DefrostYes
Noise Level51 dB
Filter TypeWashable
RefrigerantR410A
Voltage115 V / 60 Hz
ColorWhite
Operating Temperature41°F - 95°F
Dimensions15.43" x 11.34" x 24.25" (39.2 cm x 28.8 cm x 61.6 cm)

Related product manuals