7.1 Cleaning
During normal operation, the units provide maintenance-free
service.
If the units require cleaning ...:
▪ Use a soft cloth only.
▪ Do not use any solvent cleaners.
▪ Do not spray directly on the LC display or laser.
7.2 etherCON connector socket protection
NOTICE!
Possible risk of damage to the device!
Always make sure the dust cap of the etherCON connector socket
is properly attached (closed) during transport or when it is not in
use, as shown in the graphic opposite.
This prevents the sender unit from damage due to:
▪ Ingression of moisture or liquids (e.g. water from rain) through
the etherCON connector socket,
▪ corrosion of the connector socket's spring contacts.
7 Maintenance and care
d&b ArraySight Manual 1.7 en 19
To Next Page
Loading...