3. Controls and indicators
3.1. Controls
3.1.1. Power switch
The power switch [1] is a rocker switch type. It does not isolate the unit
from the mains power.
- OFF
The unit is switched off. The power consumption is low (1 W typical).
- ON
The unit is switched on and ready for operation.
3.1.2. MUTE A/B switch
When the mains power switch is set to the on position, the MUTE A/B
switches (push buttons) [2] can be used to mute the respective amplifier
channel or place the D6 in Standby mode.
Note: The setting of the MUTE A/B switch is stored in the D6 when the
mains power is turned off or disconnected. After switching on or
reconnecting the unit it will revert to its previous status.
MUTE / STANDBY
- A brief press of the MUTE A or B switch will mute the corresponding
channel A or B. The channel is unmuted by briefly pressing the
corresponding MUTE switch.
- A longer press (approx. 1.5 s) of MUTE A or B places the D6 in
Standby mode. Briefly pressing the MUTE A or B switch again powers
on the D6 ready for use. The D6 may also be powered back on by
remote control from Standby mode.
D6 Amplifier, Hardware manual (1.9 EN) Page 8 of 24
To Next Page
Loading...
