47
B. Dismount
1) Use “ Remove NDAS SCSI Controller safely……”
as in the figure below.
Or, by clicking the NDAS icon, select “Dismount” option.
2) Click [yes] to dismount your device.
3) After dismounting, you can see the current status as shown in the figure.
In the case that you receive a message saying that the device can not
be removed,
check if NDAS window is open, or whether NDAS is still operating.
(e.g. transfer, play, remove files)
When the operation of NDAS is completely finished, try dismounting
again.
4. Confirm NDAS device in Device Manager
You can check to see if your NDAS device has been installed in
“Disk Drive” and “SCSI and RAID controller” under Device Manager.
Chapter 6: How to setup NDAS
To Next Page
Loading...
Need help?
General
