MCD Remote Operator Installation
MG.17.E5.02 - VLT® is a registered Danfoss trademark 5
2.7. For use with MCD 3000
To connect the Remote Operator to an MCD 3000 soft starter:
177HA375.10
MCD 3000 REMOTE OPERATOR
RS485
SERIAL PORT
68
61
69
B1
B2
B3 B6
B7 B8
+ GND -
RS485
STARTER
RS485
NETWORK
4-20 mA
ANALOGUE OUTPUT
(MOTOR CURRENT)
B10
B11
4-20 mA
+ -
SUPPLY VOLTAGE
(18 ~ 30 VAC/VDC
12
POWER
SUPPLY
- GND +- GND +
~/+ ~/-
N.B.!:
In order for the Remote Operator to operate correctly, the MCD 3000 must be in Local
mode (set Parameter 20 = 2: Local Control Only).
To Next Page
Loading...
