To Next Page
M
Michael ManningAug 14, 2025
What to do if my Danfoss Transmitter shows a general hardware failure?
- WwatsontamaraAug 14, 2025
If your Danfoss Transmitter indicates a general hardware failure, the suggested solution is to replace the transmitter.
What to do if my Danfoss Transmitter shows a general hardware failure?
If your Danfoss Transmitter indicates a general hardware failure, the suggested solution is to replace the transmitter.
What to do if my Danfoss Transmitter shows a low battery signal?
If your Danfoss Transmitter displays a low battery signal, you should replace or recharge the battery.
What to do if a maneuver is activated at Danfoss Transmitter start up?
If a maneuver is activated during the start-up process of your Danfoss Transmitter, and no order is active, release the maneuver. If the issue persists, it may indicate hardware damage, and the transmitter may need to be replaced.
What to do if my Danfoss Transmitter is in stand-by mode?
If your Danfoss Transmitter is in stand-by mode, set up the system and press START to enter Operation mode.
What to do if my Danfoss Transmitter shows EEPROM module missing or corrupt?
If your Danfoss Transmitter indicates that the EEPROM module is missing or corrupt, check the EEPROM and reprogram it if necessary.
What to do if my Danfoss Remote Control shows a low battery signal?
If your Danfoss Remote Control shows a low battery signal, you should replace or recharge the battery.
What to do if a maneuver is activated at Danfoss IK3 transmitter start up?
If a maneuver is activated at the Danfoss Remote Control transmitter start-up process, and no order is active, release the maneuver or replace the transmitter.
How to fix general hardware failure in Danfoss IK3 Remote Control?
If you have a general hardware failure with your Danfoss Remote Control, replace the transmitter.
What to do if EEPROM module missing or corrupt in Danfoss IK3 Remote Control?
If the EEPROM module is missing or corrupt in your Danfoss Remote Control, check the EEPROM and reprogram it if necessary.
General| Brand | Danfoss |
|---|---|
| Model | IK3 |
| Compatibility | Danfoss Link™ system, Danfoss Link™ CC, Danfoss Link™ FC |
| Function | Room temperature control |
| Range | Up to 30 meters indoors |
| Power Supply | 2 x AAA batteries |
| Display | LCD |
| Operating Temperature | 0 to +50°C |
