Charger and battery
Disposal note:
This symbol on the product indicates that it may not be disposed of as household waste.
It must be handed over to the applicable take-back scheme for the recycling of electrical equipment.
•
Dispose of the product through channels provided for this purpose.
•
Comply with all local and currently applicable laws and regulations.
CB70 and BT27IK specifications
CB70 battery charger
Specification Value
Standard AC power supply 230 Vca ± 10%, 50
Optional AC power supply 115 Vca, 60 Hz
DC power supply From 10.5 V to 35 V
BT27IK battery
Specification Value
Voltage 4.8 V
Capacity 2700 mAh NiMH
Charging temperature From 0° C to 45° C
Discharge temperature From -20° C to 50° C
Autonomy From 8 to 15 h (configuration dependant)
Charging mode 7h and intelligent
Weight 156.3 g
Setting up the CB70 battery charger
Use the information below to properly set up the CB70 batter charger.
The battery charger has two charging compartments that can simultaneously charge two batteries.
1. Connect the charger to a power source using the cable supplied.
The red LED will switch.
User Manual
Remote Control IK3 Transmitters
Charger and battery
12 |
©
Danfoss | May 2021 BC290857689420en-000201
To Next Page
Loading...
