8 INFORMATION menu
Open the menu by pressing the left or right button. The menu also shows history and operating times.
Note! The menu information below describes all possible parameters. The parameters that appear in the
display vary depending on the selections made in menus (e.g. type of heat pump) and on the connected
hardware (e.g. expansion card and defrost card).
Table 8. Used to change the heat pump's operating modes and to adjust the heat curve.
Menu Sub menu Sub menu Sub menu
INFORMATION
OPERAT.
Ø CANCEL
Ø
AUTO
HEAT PUMP
AUX. HEATER
HOT WATER
MANUAL TEST
HEAT CURVE
CURVE
MIN
MAX
CURVE 5
CURVE 0
CURVE -5
HEAT STOP
REDUCTION
TANK TEMP
OVERCHARGE
ROOM FACTOR
POOL
POOL HYSTERESIS
HEAT CURVE 2 (if shunt group is activated)
CURVE
MIN
MAX
TEMPERATURE
OUTDOOR
ROOM
SYSTEM SUPPLY
SUPPLY LINE
RETURN LINE
BUFFER TANK
HOT WATER
INTEGRAL
BRINE IN
BRINE OUT
POOL
COOLING
SHUNT GROUP
2ND HEAT CIR.
CURRENT
OPERAT. TIME
46 – Installation instructions VMBMA1002
To Next Page
Loading...
Need help?
General