Danfoss DHP-C Installation Guide

4 kW 6 kW 8 kW 10 kW
400V, 3-N A
16
1,8
/20
2,8
/25
3,8
10
1
/16
2
/20
3
10
1
/16
2
/20
3
16
1
/16
2
/20
3
DHP-A, DHP-A Opti
6 kW 8 kW 10 kW 12 kW
400V, 3-N A
10
1
/16
2
/20
3
/20
4
/25
5
/25
6
/
30
7
10
1
/16
2
/20
3
/20
4
/25
5
/25
6
/
30
7
16
1
/16
2
/20
3
/20
4
/25
5
/25
6
/
30
7
16
1
/20
2
/25
3
/20
4
/25
5
/30
6
/
35
7
230V, 1-N A
16
9
+10
1
/16
2
/25
3
20
9
+10
1
/16
2
/25
3
25
9
+10
1
/16
2
/25
3
32
9
+10
1
/16
2
/25
3
1. Heat pump with 3 kW immersion heater (1-N 1.5 kW).
2. Heat pump with 6 kW immersion heater (1-N 3 kW).
3. Heat pump with 9 kW immersion heater (1-N 4.5 kW).
4. Heat pump with 12 kW immersion heater and shut off compressor
5. Heat pump with 15 kW immersion heater and shut off compressor
6. Heat pump with 12 kW immersion heater
7. Heat pump with 15 kW immersion heater
8. Fuse phase L1 (size 4 has 1-phase compressor)
9. Heat pump
6.3
Connecting external supply voltage
6.3.1 Connect external supply voltage
Danger Electrical voltage! The power cable may only be connected to the terminal block intended for this purpose.
No other terminal block may be used.
1. Route the power cable through the opening in the top panel of the heat pump to the terminal blocks.
2. Connect the power cables as follows.
6.3.2
Connection 400 V, 3-N
Isolator switch Terminal block heat pump
Incoming cable
2 1
4 3
6 5
N3 3L1 PE5 1L1 1L2 1L3 2L1 2L2 2L3 PE1
Installation Guide Domestic heat pumps
Danfoss Heating Solutions VMGFQ102
33

Danfoss DHP-C Specifications

General

Brand	Danfoss
Model	DHP-C
Category	Heat Pump
Language	English