What to do if the thermostatic control valve does not close on Danfoss Termix AT BTD?
If the thermostatic control valve on your Danfoss Boiler does not close, the temperature difference between the DH supply and the DHW set point might be too low. Try lowering the set point temperature or increasing the DH supply temperature.
How to troubleshoot too little or no DHW in Danfoss Termix AT BTD Boiler?
If you're experiencing too little or no domestic hot water (DHW) with your Danfoss Boiler, several factors could be responsible. Start by checking for a clogged strainer in the supply or return line and clean it. Ensure the DHW circulation pump is working correctly and set appropriately. A defective or clogged non-return valve can also cause issues, so replace or clean it. Confirm that there is electricity supplied to the boiler. If automatic controls are in place, verify their settings. Scaling of the plate heat exchanger may be the cause, requiring replacement or rinsing. Check the motorized valve, temperature sensors, and controller for defects, replacing as needed.
Why is there a temperature drop during tapping in my Danfoss Boiler?
A temperature drop during tapping with your Danfoss Boiler may be due to scaling of the plate heat exchanger, in which case you should replace or rinse it out. Alternatively, the DHW flow might be larger than the substation was designed for, so try reducing the DHW flow.
What to do if some taps have hot water but not all in Danfoss Termix AT BTD Boiler?
If you have hot water in some taps but not all with your Danfoss Boiler, it could be that DCW is being mixed with the DHW, possibly due to a defective thermostatic mixing valve; check and replace if necessary. Another cause might be a defective or clogged non-return valve on the circulation valve, which should be replaced or cleaned.
Why is the tap temperature too high in my Danfoss Termix AT BTD Boiler?
If the tap temperature is too high and the DHW tap load is also too high on your Danfoss Boiler, the thermostatic valve may be adjusted to a level that is too high. Check and adjust the setting accordingly.
General safety instructions and warnings for installation and operation of the substation.
Instructions and specifications for mounting the substation, including connection sizes and dimensions.
Detailed steps and diagrams for mounting the substation unit into its wall cabinet.
Overview and diagram of the Termix AT BTD 5-pipe system design.
Schematic representation of the Termix AT BTD 5-pipe system components and connections.
Overview and diagram of the Termix AT BTD 4-pipe system design.
Schematic representation of the Termix AT BTD 4-pipe system components and connections, including technical parameters.
Details on domestic hot water temperature control, including the AB-QM controller settings.
Information on other components like cold water meter fitting piece and siphon.
Recommended maintenance tasks and schedule for the substation, including strainers and safety valves.
General checks and basic troubleshooting steps for operating disturbances.
Specific problems and solutions related to Domestic Hot Water (DHW) supply and temperature.
Guidelines for proper dismantling and disposal of the substation components.
Official EU Declaration of Conformity for the Termix substations.
To Next Page
General