Danfoss VLT 5000 Series User Manual

7. Press the [OK] key.
8.
Parameter 620 is automatically set to Normal
operation.
If a test fails, the adjustable frequency drive will move
into an infinite loop. Replace control card.
Test plugs:
Inialisation [3] is selected if the factory setting of the unit
is desired without resetting parameters 500, 501 + 600
- 605 + 615 - 617.
NOTE
The motor must be stopped before initial-
isation can be carried out.
Procedure for initializing:
1. Select Initialisation.
2. Press the [OK] key.
3. Cut off the mains supply and wait for the light
in the display to go out.
4. Connect to mains.
Manual initialisation can be carried out by holding
down three keys at the same time as the mains voltage
is connected. Manual initialisation sets all parameters
to the factory setting, except 600-605. The procedure
for manual initialisation is as follows:
1. Disconnect the mains voltage and wait for the
light in the display to disappear.
2. Hold down [DISPLAY/STATUS]+[MENU]+
[OK] while at the same time connecting the
mains supply. The display will now read
MANUAL INITIALIZE.
3. When the display reads UNIT READY, the
adjustable frequency drive has been initial-
ized.
Parameter no. Description
Nameplate
Display text
621 VLT type (VLT TYPE)
622 Power section (POWER SECTION)
623 VLT ordering number (VLT ORDERING NO)
624 Software version number (SOFTWARE VERSION)
625 LCP identification number (LCP ID NO)
626 Database identification number (PARAM DB ID)
627 Power section identification number (POWER UNIT DB ID)
628 Application option type (APP. OPTION)
629 Application option ordering number (APP. ORDER NO)
630 Communication option type (COM. OPTION)
631 Communication option ordering number (COM. ORDER NO)
Function:
The key data of the unit can be read out via the display
or the serial communication port.
Description of choice:
VLT type , parameter 621:
VLT Type indicates the unit size and basic function
concerned.
For example: VLT 5008 380-500 V.
Power section, parameter 622:
The power section states the given power section be-
ing used.
For example: Extended with brake.
VLT
®
5000 Series
152 MG.51.C5.22 - VLT
p
is a registered Danfoss trademark.

Danfoss VLT 5000 Series Specifications

General

Brand	Danfoss
Model	VLT 5000 Series
Category	DC Drives
Language	English