Danfoss VLT Micro

1.4 Programming
1.4.1 Programming with LCP
For detailed information on programming, please see Programming Guide, MG.02.CX.YY.
The frequency converter can also be programmed from a PC via RS485 com-port by installing the MCT-10 Set-up Software.
This software can either be ordered using code number 130B1000 or downloaded from the Danfoss Web site:
www.danfoss.com/BusinessAreas/DrivesSolutions/softwaredownload
Illustration 1.7 Description of LCP Buttons and Display
Quick Guide VLT Micro Drive Quick Guide
8 MG.02.B6.02 - VLT
®
is a registered Danfoss trademark
11