Danfoss VLT - 3.2.5 Safety Requirements for Mechanical Installation

VLT Installation
Rev.02
16
North America
Motion Controls
Confidential / Property of Danfoss Drives A/S
Record motor data information
– Motor Power
– Motor Voltage
– Motor Frequency
– Motor Current (FLA)
– Motor Speed (RPM)
3) Pre-Installation Checks
h. Record Motor Info
3) Pre-Installation Checks
h. Record motor data information
Write down the motor nameplate information. This is important later during
programming. A conversion between HP and kW must be calculated 1Hp = 0.75kW.
In the example 20Hp = 15kW.
Motor Power = ___________________ kW
Motor Voltage = __________________ Vac
Motor Frequency = 50Hz 60Hz
Motor Current = __________________ Amps
Motor Speed = ___________________RPM