Danfoss VLT Programming Guide

Contents
1 Introduction
3
Copyright, Limitation of Liability and Revision Rights 3
Approvals 4
Symbols 4
Abbreviations 5
Definitions 7
2 How to Programme 13
Local Control Panel 13
How to Operate Graphical LCP (GLCP) 13
How to operate numeric LCP (NLCP) 18
Quick Menu mode 21
Function Set-ups 24
Main Menu Mode 27
3 Parameter Description 31
Parameter Selection 31
Main Menu Structure 31
Main Menu - Operation and Display - Group 0 32
Main Menu - Load and Motor - Group 1 48
Main Menu - Brakes - Group 2 59
Main Menu - Reference/Ramps - Group 3 63
Main Menu - Limits/Warnings - Group 4 72
Main Menu - Digital In/Out - Group 5 77
Main Menu - Analog In/Out - Group 6 93
Main Menu - Communications and Options - Group 8 102
Main Menu - Profibus - Group 9 115
Main Menu - CAN Fieldbus - Group 10 124
Main Menu - LonWorks - Group 11 129
Main Menu - Smart Logic - Group 13 131
Main Menu - Special Functions -Group 14 146
Main Menu - Frequency Converter Information - Group 15 155
Main Menu - Data Readouts - Group 16 163
Main Menu - Data Readouts 2 - Group 18 172
Main Menu - FC Closed Loop - Group 20 175
Main Menu - Extended Closed Loop - Group 21 189
Main Menu - Application Functions - Group 22 201
Main Menu - Time-based Functions - Group 23 216
Main Menu - Application Functions 2 - Group 24 232
Main Menu - Cascade Controller - Group 25 240
VLT
®
HVAC Drive Programming Guide Contents
MG.11.C9.02 - VLT
®
is a registered Danfoss trademark 1

Danfoss VLT Specifications

General

Frequency	50/60 Hz
Enclosure	IP20, IP21, IP55, IP66
Series	VLT
Control Technique	Flux Vector Control
Output Voltage	0-Vinput
Control Method	Fieldbus
Communication Interface	PROFIBUS, CANopen
Protection Features	Overload, Overvoltage, Undervoltage, Short Circuit, Ground Fault
Cooling Method	Liquid Cooled
Storage Temperature	-25°C to +70°C
Relative Humidity	5-95% non-condensing
Altitude	Up to 1000m (3280ft) without derating, up to 4000m (13120ft) with derating
Operating Temperature	-10°C to +50°C (14°F to 122°F)