[10] Filter
[11] Drive cooling fan
[12] System health check
[13] Warranty
[20] Maintenance Text 0
[21] Maintenance Text 1
[22] Maintenance Text 2
[23] Maintenance Text 3
[24] Maintenance Text 4
[25] Maintenance Text 5
23-11 Maintenance Action
Option: Function:
Select the action to be associated with the Preventive Maintenance Event.
[1] * Lubricate
[2] Clean
[3] Replace
[4] Inspect/Check
[5] Overhaul
[6] Renew
[7] Check
[20] Maintenance Text 0
[21] Maintenance Text 1
[22] Maintenance Text 2
[23] Maintenance Text 3
[24] Maintenance Text 4
[25] Maintenance Text 5
23-12 Maintenance Time Base
Option: Function:
Select the time base to be associated with the Preventive Maintenance Event.
[0] * Disabled
Disabled
[0] must be used when disabling the Preventive Maintenance Event.
[1] Running Hours
Running Hours
[1] is the number of hours the motor has been running. Running hours are not reset
at power-on. The
Maintenance Time Interval
must be specified in par. 23-13
Maintenance Time
Interval
.
[2] Operating Hours
Operating Hours
[2] is the number of hours the frequency converter has been running. Operating
hours are not reset at power-on. The
Maintenance Time Interval
must be specified in
par. 23-13
Maintenance Time Interval
.
[3] Date & Time
Date & Time
[3] uses the internal clock. The date and time of the next maintenance occurrence
must be specified in par. 23-14
Maintenance Date and Time
.
3 Parameter Description VLT
®
HVAC Drive Programming Guide
222
MG.11.C9.02 - VLT
®
is a registered Danfoss trademark
3
To Next Page
Loading...
