8-85 Slave Timeout Errors
Range: Function:
0 N/A* [0 - 0 N/A]
3.9.9 8-9* Bus Jog
Parameters for configuring the Bus Jog.
8-90 Bus Jog 1 Speed
Range: Function:
100 RPM* [Application dependant] Enter the jog speed. This is a fixed jog speed activated via the serial port or fieldbus option.
8-91 Bus Jog 2 Speed
Range: Function:
200 RPM* [Application dependant] Enter the jog speed. This is a fixed jog speed activated via the serial port or fieldbus option.
8-94 Bus Feedback 1
Range: Function:
0 N/A* [-200 - 200 N/A] Write a feedback to this parameter via the serial communication port or fieldbus option. This pa-
rameter must be selected in par. 20-00
Feedback 1 Source
, par. 20-03
Feedback 2 Source
or
par. 20-06
Feedback 3 Source
as a feedback source.
8-95 Bus Feedback 2
Range: Function:
0 N/A* [-200 - 200 N/A] See par. 8-94
Bus Feedback 1
for further details.
8-96 Bus Feedback 3
Range: Function:
0 N/A* [-200 - 200 N/A] See par. 8-94
Bus Feedback 1
for further details.
3 Parameter Description VLT
®
HVAC Drive Programming Guide
114
MG.11.C9.02 - VLT
®
is a registered Danfoss trademark
3
To Next Page
Loading...
