Danfoss VLT Programming Guide

Main Menu - Analog I/O Option MCB 109 - Group 26 253
4 Troubleshooting 263
Alarm Words 267
Warning Words 268
Extended Status Words 269
Fault Messages 270
5 Parameter Lists 277
Parameter Options 277
Default settings 277
0-** Operation and Display 278
1-** Load / Motor 279
2-** Brakes 280
3-** Reference / Ramps 280
4-** Limits / Warnings 281
5-** Digital In / Out 282
6-** Analog In / Out 283
8-** Communication and Options 284
9-** Profibus 285
10-** CAN Fieldbus 286
11-** LonWorks
286
13-** Smart Logic Controller 287
14-** Special Functions 288
15-** FC Information 289
16-** Data Readouts 291
18-** Info & Readouts 293
20-** FC Closed Loop 294
21-** Ext. Closed Loop 295
22-** Application Functions 297
23-** Time Based Funtions 298
24-** Application Functions 2 299
25-** Cascade Pack Controller 300
26-** Analog I / O Option MCB 109 301
Index
302
Contents VLT
®
HVAC Drive Programming Guide
2 MG.11.C9.02 - VLT
®
is a registered Danfoss trademark

Danfoss VLT Specifications

General

Frequency	50/60 Hz
Enclosure	IP20, IP21, IP55, IP66
Series	VLT
Control Technique	Flux Vector Control
Output Voltage	0-Vinput
Control Method	Fieldbus
Communication Interface	PROFIBUS, CANopen
Protection Features	Overload, Overvoltage, Undervoltage, Short Circuit, Ground Fault
Cooling Method	Liquid Cooled
Storage Temperature	-25°C to +70°C
Relative Humidity	5-95% non-condensing
Altitude	Up to 1000m (3280ft) without derating, up to 4000m (13120ft) with derating
Operating Temperature	-10°C to +50°C (14°F to 122°F)