VLT Installation
Rev.02
3
North America
Motion Controls
Confidential / Property of Danfoss Drives A/S
Student is able to…
• State the main danger and precaution to be taken
when working with a VLT.
• Identify the Reference Material needed for an
installation and where that material may be found.
• Locate and explain each of the 9 steps needed during
the pre-installation checks.
• Identify the 4 installation checks for proper operation.
• Identify the correct terminals and general instructions
concerning the wiring of the power input, motor
output, control, external 24Vdc, brake and load-
sharing.
Objectives
Objectives
These objectives are listed as a goal for this training module. A review at the end of
this module tests the student concerning these objectives.
To Next Page
Loading...
