FCC STATEMENT
his equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
hese limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications However, there is no guarantee that interference will not occur in a particular installation
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
e declare that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU
Satisfies all the technical regulations applicable to the product within the scope of I.JK Radio Equipment Regulations (SI 2017/1206);
LJKElectrical Equipment (Safety) Regulations (SI 2016/1101); and CJKElectromagnetic Compatibility Regulations (SI 2016/1091)
his device operating RP < 23dBm) ,
5250-5350M < 13.9BdBm)
17
To Next Page
Loading...
