Need help?Do you have a question about the Daniels P25 and is the answer not in the manual?
Explains operational differences between MT-4R and MT-4D modules, focusing on mixed mode.
Explains how receivers and transmitters work in analog or P25 digital mode without reprogramming.
Explains how P25 digital signals are received and retransmitted, including TGID, NAC, and status symbols.
Explains how MT-4R and MT-4D modules configure as repeaters.
Describes configurations using up to 4 sets of transceivers with the CI-RC-4M controller.
Explains using analog audio for repeat path and wireline control with CI-BC-4E base controller.
Details operation of P25 Analog Controlled Base Stations in encrypted or clear modes.
Explains how to connect a PC to the radio using RSS software and RPIM.
Details which software versions to use for different MT-4 series modules.
Describes the RSS4D-R software for MT-4D Repeater modules.
Describes the RSS4D-BASE software for MT-4D Base modules.
Explains independent programming of receiver and transmitter modules using RSS.
Details the programming of the CI-RC-4M Multiple Link Controller.
Describes the SR-39-1 subrack for holding MT-4 series modules.
Explains 16-channel operation controlled by CSEL signal lines.
Describes the SM-3 system monitor module for voltage regulation, metering, and audio monitoring.
Discusses RF power output and Daniels' 30 Watt power amplifier.
To Next Page
General