EasyManua.ls Logo

Dantherm HCV7 - Water drainage

Dantherm HCV7
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
Water drainage
Introduction
As the unit absorb the heat from the extracted air, air with high humidity will conden-
sate to water drops. This water is harmful to its surrounding if not managed correctly
Drainage connection
Connect a water drainage hose to the Appropriate water outlet spigot, in the bottom of
the unit. The unused spigot is to be closed with a blind.
The drainage hose has to be fitted with a water trap not smaller than 100 mm water
column, made as a loop or two bends on the hose.
Route the hose to Appropriate water sever, securing that the hose cannot freeze to ice.