Dantherm HCV7 - Page 37

37
092889• Version 1.1• 21.06.2016
Error list, continued
Remote control error
readings
Any error is also shown with an “E” + any number indication on a connected remote
control. In this case the error specification can be read in the previous shown error ta-
ble, as well as in the remote control manual.
PC tool
Any operation warning or error is always logged in the memory of the controller. Con-
nect a computer running the PC-tool to the USB and readout detailed information
Resetting errors
Re-starting the unit (disconnect/connect to 230V) will reset the controller, and the unit
will start normal operation, and also restart a new search for possible errors. This could
last up to 15 minutes.