5
The ceramic honing rod included with the E5 ELECTRIC SHARPENER was designed
to work in combination with the E5 ’s 17° STANDARD GUIDES. Use the ceramic rod to
further refine an edge or to quickly maintain an edge between sharpenings.
CERAMIC HONING ROD
Sharpening Guide
Sharpening Guide
MicroForge
For best results, use built-in angle guides.
1.
Insert the ceramic rod into the handle.
2. Hold the handle vertically with the rubber tip of
the honing rod resting on a cutting board.
3. Place the heel of your knife against one of the
guides to establish the proper sharpening angle.
While maintaining the angle established by the
guide, slowly draw the entire length of blade,
from heel to tip, along the full length of the
ceramic rod. Use light pressure.
4. Repeat 10 slow, alternating strokes.
TIP: Lighter pressure creates sharper results.
To Next Page
Loading...