Dash DEM001H - Using Your Electric Mandoline

using your electric mandoline ∙ 11 10 ∙ using your electric mandoline
using your electric mandoline using your electric mandoline
1
2
2a
3
4
5
Set Motor Base on stable surface and place Processing Base
on top. Processing Base is a necessary part when using the
mandoline. Make sure to place the Processing Base on motor
unit before placing the Blade on base.
Clean the Electric Mandoline and all of its components prior to assembly and use.
Remove any stickers and packaging before rst-time use.
DO NOT use the appliance to shred tough or hard foods such as meat or ice cubes. You
may need to cut larger foods into pieces so that they can t inside the Processing Chute.
Assemble Blade of choice (see Assembling Blades and Inserts
on page 12 for instructions).
Set Blade on Processing Base, ensuring that the tab
under the Blade is inserted into notch in the Motor
Base.
NOTE: This notch will be in a different place each time
you stop the Mandoline. Pay careful attention to make
sure that the tab is inserted INTO the notch and not in
front of or behind the notch.
Set Blade on Processing Base, ensuring that the tab
under the Blade is inserted into notch in the Motor
Base.
NOTE: This notch will be in a different place each time
you stop the Mandoline. Pay careful attention to make
sure that the tab is inserted INTO the notch and not in
front of or behind the notch.
Place Lid over Processing Base, matching up notches on Lid
with the slots on the Motor Base.
Once notches are aligned, place hand on the back of
the Lid (near the Power Button) and push Lid forwards
while stabilizing the Mandoline with your other hand to
lock the Lid into place.
Slide Container under the Motor Base, making sure to align
the sides of the Container with slots under the Motor Base until
the red arrow on the Container lines up with the red arrow on
the underside of the Motor Base.
NOTE: There is a micro-switch under the Mandoline that will
not be activated if the Container is not inserted properly.
Plug in Electric Mandoline. Place food in Processing Chute and
use Pusher to press food into Chute. Hold down Power Button
to begin slicing food. Release Power Button to stop.