Dash GUARDIAN User Manual

About the Guide
Step 1 Use the guide to mark & drill holes for the drywall anchors.
Step 2
Attach the mounting plate by drilling the provided screws
into the anchors from step 1.
Step 3
Attach the camera to the magnetic mounting plate,
and adjust lens as needed.
Step 1
Step 3
Connect the camera to a power source.
Scan the QR code or search “IC Realtime” in the Google Play
or App Store to download and install DASH App.
Step 5
Step 4
With your mobile device connected to a 2.4 GHz band, add a
camera by following the steps depicted below.
Run the DASH App, and then register a new account if you
do not already have one.
Step 2
The camera LED indicator will flash green when it is fully booted on.
Note:
Note:
If camera fails to to add or the WiFi connection is
changed. Reset the camera and repeat step 5.
Repeat step 5 for adding multiple cameras.
Mounting Surface
Hole Guide
Drywall Anchors
Mounting Plate
Self-tapping Screw
Camera
Make sure the mounting surface can hold at least 1lb.
This quick start guide is for reference only. Minor
difference might be found in user interface.
All the design and software here are subject to
change without prior written notice.
All trademarks & registered trademarks mentioned
are the properties of their respective owners.
Please visit our website or contact your local
service engineer for more information.
If there is any uncertainty or controversy, please
refer to our final explanation.
-
-
-
-
-
Using the Dash App Camera Installation

Dash GUARDIAN Specifications

General

Resolution	1080p Full HD
Two-Way Audio	Yes
Field of View	130°
Night Vision	Up to 30 feet
Motion Detection	Yes
Storage	Cloud and local storage options
Connectivity	Wi-Fi
Weather Resistance	IP65

Summary

Using the Dash App

Download and Install DASH App

Scan QR code or search "IC Realtime" in Google Play or App Store to download and install the DASH App.

Account Registration and Initial Setup

Run the DASH App, register a new account if needed, and connect the camera to a power source.

Adding Camera via Mobile Device

Connect your mobile device to a 2.4 GHz band Wi-Fi and follow the depicted steps to add the camera.

Camera LED Indicator Status

The camera LED indicator will flash green when it is fully booted on.

Camera Installation

Mounting Preparation and Drilling

Use the guide to mark and drill holes for drywall anchors, ensuring the surface can hold at least 1lb.

Attaching Mounting Plate and Camera

Attach the mounting plate by drilling screws into anchors, then attach the camera and adjust the lens.

What's in the Box

Know Your Guardian