18
3.8.2 Mini DAP-III Units
The optional Mini DAP-III microprocessor control panel normally comes with the sensors mounted
in the display module. Although these existing sensors can be removed for remote mounting, the
remote sensor option provides a more convenient means of fi eld installation. When ordered, the
remote sensors are shipped with a predetermined length of cable and come mounted in a plastic
enclosure. The temperature and humidity sensors require a total of six wires. These wires should
be twisted, shielded type.
3.9 Condensate Pumps
An optional condensate that pumps ships loose normally require a separate power source (110
volt). Always check the pump power requirements before connecting power. Condensate pumps
are available in other voltages.
Condensate pumps that are factory wired and mounted do not require any additional wiring or a
separate power source. However, fi eld piping is still required.
To Next Page
Loading...
