31
WARNING: The Remote Mount DAP-III microprocessor control panel has an
entire manual dedicated to its use and operation. The manual must be refer-
enced to complete a thorough unit installation. Start-up is not complete until
the Mini DAP-II control panel settings are established.
7.6 Wiring Diagrams
Every Data Aire evaporator, condenser, condensing unit or fl uid cooler comes with a wiring diagram.
These diagrams are ladder type schematics intended for service personnel. The intent is to allow
the technician to understand the wiring details associated with the electrical components and how
they interface with the controls as well as peripheral equipment (including secondary heat exchang-
ers).
The wiring diagram in the evaporator will indicate fi eld interface terminals to the secondary heat
exchanger. The internal wiring of the heat exchanger is found on a separate diagram which can be
found on the inside cover of the heat exchanger electrical box. Both diagram types are also placed
inside the shipping/warranty packet secured in the evaporator section.
Evaporator wiring diagrams will have a drawing number that starts with a three letter designation,
“DAM”. An example of a typical diagram is DAM-S-778. Wiring diagrams for condensers or con-
densing units start with the three letter designation, “DRC”. A typical diagram example would be
DRC-S-001. Fluid coolers begin with the three letter designation “DFC”. A typical fl uid cooler dia-
gram would be DFC-S-001.
To Next Page
Loading...
