10-2014 gForce User Manual ● 55
shipped from the factory with the password requirement bypassed to accommodate
start-up and set-up. The display screen will have following message:
The Service Level Password setting from the factory is: 0000
The cursor will be flashing by the Security Access message at the top of the screen.
Press the ENTER key to move the cursor. The cursor will flash at the first input
(represented by a 0). Press the UP or DOWN keys to increase or decrease the value.
Once the value is entered, press the ENTER key to move to the next input. Increase or
decrease the value by pressing the UP or DOWN keys. Once the value is entered, press
the ENTER key to move to the next input.
Once all four values have been entered, press the ENTER key. If the password is
incorrect, the following message will appear: Password Wrong! The cursor will return
to the first input value. Follow the same procedure to re-enter the password.
Once the correct password is entered and accepted, the Menus will display on the
screen. Only those Menus allowed through the Service Password will be available. Use
the UP or DOWN keys to scroll through the available. Use the UP or DOWN keys to
scroll through the available Menus.
NOTE:
Factory Level menus are for configuring the unit. The dap4™
controller is used for a variety of equipment types. The controller is based
on the unit type, unit components and options. Under normal circumstances
these menus should not be changed. If they need to be changed, please
To Next Page
Loading...
