10-2014 gForce User Manual ● 65
Press the ENTER key to move the cursor. Follow the same procedure until all desired
changes are made. Return the cursor to the title line (at the top of the screen) by
pressing the ENTER key.
You also have the option to reset all runtimes (Screens 1 thru 3) by moving the cursor
to “Reset All Runtimes”.
To exit Menu E, with the cursor on the title line, press the MENU key.
Advance to Menu F (Information) by pressing the DOWN key.
8.2.6 Menu F – Information
This is a view only menu. Menu entry requires a service password to enter.
There are three screens – two with information detailing the processor version and
data. The third screen details unit information including model number, serial number
and Data Aire job number.
To view the screens, press the DOWN key. The cursor will not move as this is a view
only screen. When calling for technical assistance please have the serial number from
the Unit Identification screen.
Press the Menu key to exit Menu F
8.2.7 Menu G – Network Config
This menu allows programming of available protocols. Menu entry requires a service
password. This is a factory set menu dependent on whether optional communication
cards were ordered.
The following will appear on the screen (values are for reference only):
To Next Page
Loading...
