70 ● gForce Ultra User Manual 10-2014
For all of the displays above, the cursor will flash by the Offset value. Press the UP or
DOWN key to change the Offset value.
An independent calibrated meter should be used to verify the values before changing
Offset.
Press the ENTER key. The cursor will advance to the title page. The Offset will be
displayed and the Value will automatically change adding or subtracting the Offset.
With cursor on the title, Press the DOWN key to advance to the next screen.
Press the MENU key to exit Menu H – Calibrate Sensors
Press the ENTER to advance to Menu I – Manual Control
To Next Page
Loading...
