GAME SPECIFICATIONS
POWER REQUIREMENTS
This game Is provided with a 3-prong plug and must be connected to a properly grounded outlet to reduce
shock hazard and insure proper game operation. Refer to AC Power Wiring Diagram for transformer connections
required for normal, high, and low line conditions.
Normal Line: 109 to 129 Vac (211 to 225 Vac)
High Line: (226 to 235 Vac)
Low Line: 95 to 108 Vac (200 to 210 Vac)
MAJOR ASSEMBLY AND FUSE LOCATIONS
Referto thè Game lllustration (page 2) to Identify locations of thè major assemblles, and fuse values and locations.
PROM SUMMARY
CPU Board: Location 5B, 5C
Sound Board: Locations U17 (Voice ROM1), U21 (Voice ROM 2), and U7 (Sound ROM)
Display Board: Location U8
TRANSPORTATION
To reduce thè possibility of damage, observe thè following precautions wh
enever transporting thè game. Lower
thè backbox and secure it to thè cabinet. Remove thè legs and secure thè game within thè transporting vehicle.
GAME ASSEMBLY PROCEDURES
(Refer to thè Game lllustration on page 2)
1. Open thè top of thè carton and lay it on its side with thè bottoni of thè cabinet down. Using thè plastic bandlng
strip as a handle, slide thè game out of thè carton.
2. Remove all packing material. Locate cabinet legs in filler packing Inserts and assembly parts package In thè
cashbox. There sho
uld be four leg levelers, eight leg bolts, three pinballs and a large Alien Wrench used for
securlng thè backbox.
3. Attach leg leveler from thè parts package to each leg, make sure that each leveler is threaded through a hex
nut before threading it into thè leg.
Support rear of cabinet and attach rear legs using two leg bolts for each leg.
Support front of cabinet and attach front legs using two leg bolts for each leg.
6. While assuring that no cables are belng pinched, carefully raise thè backbox and secure it in Its uprlght posltlon
by inserting thè Alien Wrench in thè hole in thè back of thè cabinet and rotating thè wrench 270 degrees(3/4 tum).
Game & Feature Specifications
To Next Page
Loading...
