Installing the Board and Loading the Device Driver
25
Unpacking
Open the shipping box and remove the wrapped DT3000 Series board.
Verify that the following items are present:
• DT3000 Series data acquisition board
• Data Acquisition OMNI CD
If an item is missing or damaged, contact Data Translation. If you are in the United States, call
the Customer Service Department at (508) 481-3700, ext 1323. An application engineer will
guide you through the appropriate steps for replacing missing or damaged items. If you are
located outside the United States, call your local distributor, listed on Data Translation’s web
site (www.datatranslation.com).
Once you have unpacked your board, check the system requirements, as described in the next
section.
CAUTION:
Keep the board in its protective antistatic bag until you are ready to
install it; this minimizes the likelihood of electrostatic damage.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General