Installing the Board and Loading the Device Driver
29
Loading the Device Driver
To load the DT3000 Series device driver in:
• Windows XP, follow the steps on page 29.
• Windows Vista, follow the steps on page 29.
• Windows 7, follow the steps on page 30.
Windows XP
Once you have installed the software from the Data Acquisition OMNI CD, installed a DT3000
Series board, and powered up the host computer, the New Hardware Found dialog box
appears. Do the following to load the device driver in Windows XP:
1. Click Next.
2. Click Search for a suitable driver for my device (recommended).
3. Click Specify a location, and click Next.
4. Browse to Windows\Inf\DT3000.Inf, and then click Open.
5. Click OK.
6. Click Next.
The files are copied.
7. Click Finish.
Once the driver is loaded, perform the steps in Chapter 3 starting on page 31 to attach and
configure the screw terminal panel and signal conditioning backplane.
Windows Vista
Once you have installed the software from the Data Acquisition OMNI CD, installed a DT3000
Series board, and powered up the host computer, the New Hardware Found dialog box
appears. Do the following to load the device driver in Windows Vista:
1. Click Locate and install driver software (recommended).
The popup message "Windows needs your permission to continue" appears.
2. Click Continue.
The Windows Security dialog box appears.
3. Click Install this driver software anyway.
The driver files are installed.
Once the driver is loaded, perform the steps in Chapter 3 starting on page 31 to attach and
configure the screw terminal panel and signal conditioning backplane.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General