Memor™ 10
Four Slot Battery Charger
Quick Start Guide
Overview
The Memor 10 four slot battery charger simultaneously charges up
to four spare batteries.
Parts and Functions
Set Up
To prevent the risk of short-circuiting, connect wall power in the
following order:
1. Connect the four slot battery charger to the power supply.
2. Connect the power supply to the power cord.
3. Connect the power cord to the wall outlet. The Power ON LED
illuminates green.
3
1
2
Charge the Spare Batteries
To charge up to four spare batteries:
1. Insert the spare battery into the slot with the contacts side facing
down and then gently push it into place. Ensure the label side is
facing front. The spare battery charge LED illuminates red.
2. When charging is complete, the spare battery charge LED turns
green. Lift the battery out of the slot.
The spare battery pack recharging slot is compatible with the following
Datalogic p/n: 94ACC0191 BATTERY, MEMOR 10.
The Memor 10 four slot battery charger could get warm during
charging, this is normal and does not mean a malfunction.
NOTE
Annual replacement of rechargeable battery pack avoids
possible risks or abnormalities and ensures maximum
performance.
CAUTION
LED Indicators
LED Status
Power ON
Solid green Charger is powered
Spare Battery Charger
Solid red Spare Battery is charging.
Solid green Charging is complete.
Technical Specifications
Electrical Features
Consumption Max 3 A
Indicators Consumption Power on LED (green)
Spare battery charge LED (bicolored)
Environmental Features
Working Temperature
1
0°C to 40°C
Storage Temperature -30°C to 70°C
Humidity 5-95% non-condensing
Mechanical Features
Dimensions 165.8 x 165.8 x 57.3 mm / 6.5 x 6.5 x 2.25 in
Weight 475 g / 16.75 oz
1. Charging between 15 to 40 degrees is recommended to reach the maximum
charging capability.
Power ON LED
Spare Battery Slots
Spare Battery Charge LEDs
822002810 (Rev. A) Feb. 2019
To Next Page
Need help?
General
Weight and Dimensions
