DATAMAN S4 MANUAL
14<$IComputer Operation>Computer Operation<$&Computer>
The ADVANCED SETUP has variables which
can be modified to change the
tones made by the beeper.
<$IComputer
Operation>Computer
Operation<$&Computer>
There are two ways of using S4. The obvious way
is to enter commands
by pressing keys and reading the 80-character
LCD. The other way is
to attach an <$IRS232;Remote operation>RS232
interface lead and enter
commands from your computer and see the results
on the screen. There
are differences between Stand-alone and Remote
operation, but each
key on S4's keypad has an equivalent two
character serial command. S4
always responds to the requesting device: keypad
commands produce
responses in the LCD, computer commands
produce screen responses.
S4 will respond to either device from the
command prompt; no switching
of modes is necessary. <$IRS232;Connection and
disconnection>If you
disconnect the RS232 interface during a command
it may be necessary
to switch-off-and-on-again to regain control at the
keypad.
Once a function has been entered from either the
computer interface
To Next Page
Loading...