Dataman S4 - Getting Started Quickly; PROM Copying and Configuration

DATAMAN S4 MANUAL
20 Getting Started Quickly
If you have a problem with BBS:
Once on-line, during normal office hours, if you
are stuck, lost or
cannot locate a file, go to the Main Menu and
press P to page the
SysOp. The SysOp will then give you assistance,
on screen.
Getting Started Quickly
A guide for those who do not want to read the
manual.
Copying an PROM
If you want to make copies of a master PROM into
blank PROMS of the
same type, you must go through four stages:
@BULLET = 1) Configure S4 for the PROM
type
@BULLET = 2) Load the MASTER PROM
into S4.
@BULLET = 3) Test that the new PROMS are
blank.
@BULLET = 4) Burn the new PROMS
Configuring a PROM.
@BULLET = 1) Place the MASTER PROM in
the socket with the notch at
the top. If it has less pins than the socket make
sure that it is
at the bottom.
@BULLET = 2) Press PROM. Choose the
manufacturer with the <F129M>a
<F255>and<F129>
b<F255D> keys. Then choose the right part
number with the <F129M>c<F255D> and