DATAMAN S4 MANUAL
<$IKEY;INFO>INFO<$&INFO> KEY 29
is switched on again, if no valid handshake can be
seen. Otherwise
S4 would hang-up waiting to send the introductory
message.
<$IKEY;INFO>INFO<$&INFO>
KEY
@COMPUTER TEXT = E |||||||||||||||<< F<R>
BATT 8.8V, 24<198>C<R>
CHARGER DISCONNECTED<R>
OR OFF AT SUPPLY.
This is a keypad only command: there is no
terminal equivalent.
INFO displays and continuously monitors battery
voltage and temperature,
and tells you whether the charger is connected and
turned on. <R>
The charger normally looks after itself and it
needs no assistance.
S4 is powered by a rechargeable battery of 7 nickel
cadmium cells
providing 8.4 volts 600ma/hr. Charging is
automatic: you do not have
to turn the charger on or off.
The charger turns on automatically when the
FUEL GAUGE indicates that
battery is less than 25% charged. You do not have
to switch the charger
on or off deliberately, but you can do so if you
wish in INFO mode
by pressing<F129M> c<F255D> or
<F129M>d<F255D>. If the charger is attached
and switched
on, you will see the battery voltage rise as the
battery charges. When
To Next Page
Loading...