Datamax DGL - Active and Character Set Configuration

PPI/DGL SETUP Submenu
13
PPI/DGL SETUP Submenu
Active
This setting determines if the DGL parser should process all incoming data or
pass all the data to the underlying emulation.
• Yes. DGL is active; processes all DPL commands.
• No. DGL is inactive; data is processed by underlying emulation.
The default is Yes.
Character Set
Allows the operator to select the character set.
PPI/DGL SETUP
Con’t
Process*
Heat CMD (H)
2
Notes:
* = Factory Default.
1
These menus are only present when ‘User Defined’ is
selected in the ‘Control Codes’ menu.
2
These menus are only present when ‘Admin User’ is set to
‘Enable’ in the ‘PRINTER CONTROL’ menu.
Ignore
0* (-100 to 100 dots)
Row Offset 0 * (0-99.99 Inch
Column Offset
0* (0-99.99 inch
Format Attrib.
XOR * Transparent
Error Handling
Off* Report
Opaque
Beep
Process*
Speed CMD (P,S)
2
Ignore
Process*
Cut CMD (o,:,c)
2
Ignore
Process*
Format Attr. (A)
2
Ignore
Process*
Length CMD (STXc)
2
Ignore
Process*
Soft. Switch (V)
2
Ignore
Process*
Sensor Cmd (e,r)
2
Ignore
Vert. DPI Adjust
2