1 Introduction ......................................................... 11
About This Manual............................................................................... 11
Coax/Twinax Interface Requirements ........................................... 11
PPI/DGL SETUP Menu........................................................................ 12
PPI/DGL SETUP Submenu........................................................... 13
Active ...................................................................................... 13
Character Set.......................................................................... 13
Euro Character ....................................................................... 14
Control Codes......................................................................... 14
Feedback Chars ..................................................................... 14
Default Module........................................................................ 14
Units of Measure..................................................................... 14
Row Offset .............................................................................. 15
Column Offset......................................................................... 15
Format Attrib. .......................................................................... 15
Error Handling......................................................................... 15
Vertical DPI Adjust.................................................................. 16
Command Ignore Menus ........................................................ 16
Length Cmd (STXc) ................................................................ 16
Heat Cmd (H).......................................................................... 16
Speed CMD (P,S) ................................................................... 16
Cut Cmd (o,:,c) ....................................................................... 16
Soft Switch (V) ........................................................................ 16
Sensor Cmd (e,r) .................................................................... 16
Format Attr.(A) ........................................................................ 16
2 Fully Supported Commands ............................... 17
System-Level Command Functions .............................................. 17
STX A - Set Time and Date .................................................... 17
STX a - Enable Feedback Characters .................................... 17
STX B - Get Printer Time and Date Information ..................... 17
STX c - Set Continuous Paper Length.................................... 17
STX E - Set Quantity For Stored Label................................... 17
STX e - Select Edge Sensor................................................... 17
STX F - Form Feed................................................................. 18
STX G - Print Last Label Format ............................................ 18
Table of Contents
To Next Page
Loading...