Datamax DGL - Page 44

To Next Page

To Previous Page

Chapter 3

<STX>KO GPIO Output

PTX has its own GPIO configuration methods

<STX>KS Configure Scalable Font Cache Size

PTX Font cache is configured in

PRINTER CONTROL

<STX>P Enter Character Dump Mode

HexDump Mode is available in

DIAGNOSTICS

<STX>T Printhead Dot Pattern Test Label

<STX>Z Print Configuration and Dot Pattern Labels

DIAGNOSTICS -> Printer Tests

<STX>J Set Pause for each label

<STX>p Controlled Pause

These commands can be supported by using PAA to filter out the

commands, and have GPIO put the printer in Single Label Mode.

A panel-key can then be assigned by GPIO to either print the next

label (for

<STX>J

), or disable pause mode again (for

<STX>p

Partially Supported Commands

<STX>t Test DRAM Memory Module

<STX>w Test FLASH Module

This command tests the DRAM / Flash, and reports back to the

host. DGL always reports ‘OK’ status.